产品展示

产品展示

current position: Home > Product Center > Furniture Edging

Contact usContact Us

Suzhou HuiYuFa Precision Mold Co.

Contact: Mr. Yu

Handphone:+86 136 3634 2341

Tel:+86 0512-63937361

Address:www.shwenzhi.com

Address:No.16 East Concentric Road, Awanping Community, Songling Town, Wujiang District, Suzhou, Jiangsu, China.

Furniture edging

Furniture edging

  • Category:Furniture Edging
  • Browse number:
  • QR code:
  • Release time:2021-07-19 16:02:38
  • Product description

Furniture edging effect is good or bad by these parts of the decision, edging machine, hot melt adhesive, edging strip, edging operation, the previous article we introduced the hot melt adhesive in the edging process is prone to problems and some should pay attention to matters, today I will be from the edging machine as well as the edging operation to discuss the impact of their quality of furniture edging.


1, hit the board: edge machine sawing unit appeared to hit the board, you should check the open material board whether there is a step, cutter is normal: if the cutter is not normal, you need to check whether the air pressure is stable; if the cutter is normal, then the board will be turned over, and then processed.


2, scraping: when the height of the board pieces and sealing machine set the height of the pressure beam does not match, sealing is easy to appear scraping phenomenon.


When there is scraping problem, firstly check whether the board is rising, and then check whether the scraping unit is working normally. If the board and processing components are in a normal state, then check whether there is any adhesive block attached to the slider and pressure wheel, and clean it up in time. If there is no problem, then look at the tool (scraper and spatula knife) whether there is loose, whether the tool position is adjusted in place.


3, flush is not flush: flush is not flush with the reason may be broken edge sealing strip long, resulting in smooth edge sealing strip appear gap, hide glue, or sawing unit sawing instability appear cut bad, not flush, protruding and other phenomena.


For the phenomenon of flush not flush, we should first confirm whether it is the front saw or the back saw problem, whether it is cut to the board or the edge of the strip margin is large. After finding the reason, then make corresponding adjustments to the sawing unit.


Tags

Previous:Furniture edging2021-07-19
Next:Furniture edging2021-07-19
  • 菜单
National Service Hotline

+86 136-3634-2341

Contact: Mr. Yu

Cell Phone:+86 13636342341

Telephones:+86 0512-63937361

Web Address:www.shwenzhi.com

AddressNo. 16, East Concentric Road, Yuanping Community, Songling Town, Wujiang District, Suzhou, China

底部二维码

Scan a Code

Copyright © Suzhou HuiYuFa Precision Mold Co. All rights reserved
Technical Support: Xiangyun platform